Back to Blog
![]() ![]() Please come back and use the comments section below to help others with your recommendations and what you did differently.Don’t forget to add OIL to your engine.The bolts need to be tightened to 10 Nm if they have a pre-tapped thread or 15 Nm for a non-tapped thread. Common Problems on Mercedes Kompressor EngineHere at Ecuboot, we offer German Automotive Diagnostic Trainings such as: Mercedes, BMW, Volkswagen and Audi.We. Tighten the three screws, preferably using a torque wrench like the torque wrench. ![]() Install the new sensor by pushing it in the place of the old one and installing the three screws you removed earlier.There may be some oil that will come out when you remove the oil level sensor B40. Pull the oil level sensor down carefully.Remove the bolts that hold the sensor in place using E-10 socket. ![]() You must press the small tab on the connector and pull it out.
0 Comments
Read More
Leave a Reply. |